Oki B6200 Maintenance Manual page 333

Removal
1) Remove the COVER REAR 250 (PL9.1.12). (RRP9.4)
2) Remove the FUSER ASSY (PL8.1.20). (RRP8.8)
3) Place the printer down on its left side.
Be careful not to scratch the cover, and do not given a shock to the printer from a
top.
4) Open the COVER OPEN (PL1.1.2).
5) While lifting up the boss of the HOLDER LEFT (PL6.1.14) at the back of the 250 FEEDER ASSY,
shift the HOLDER LEFT in the direction of the arrow to remove 3 hooks.
6) Remove the HOLDER LEFT from the SUPPORT NUDGER (PL6.1.13). At the same time, the
ACTUATOR NO PAPER (PL6.1.15) is removed.
Replacement
1) Install the HOLDER LEFT (PL6.1.14) and ACTUATOR NO PAPER (PL6.1.15) to the SUPPORT
NUDGER (PL6.1.13).
Be sure to install the shafts on both ends of the ACTUATOR NO PAPER into the
HOLDER LEFT and SUPPORT NUDGER.
Assemble the hook of the ACTUATOR NO PAPER to the HOLDER LEFT as shown
in the figure.
2) Move the HOLDER LEFT in the opposite direction of the arrow, and secure it to the 250 FEEDER
ASSY with the 3 hooks.
After installing, move the ACTUATOR NO PAPER with a finger, and make sure that
the ACTUATOR NO PAPER operates smoothly.
3) Return the printer to the normal use state.
4) Install the FUSER ASSY (PL8.1.20). (RRP8.8)
5) Install the COVER REAR 250 (PL9.1.12). (RRP9.4)
Chapter 3 Removal and Replacement Procedures (RRPs)
3 – 169