Oki B6200 Maintenance Manual page 299

Removal
1) Remove the COVER REAR 500/COVER REAR 250 (PL10.2.21/PL9.1.12). (RRP10.9/9.4)
2) Remove the FUSER ASSY (PL8.1.20). (RRP8.8)
3) Remove the COVER REAR (PL1.1.3). (RRP1.1)
4) Remove the FAN MAIN (PL12.1.10). (RRP12.6)
5) Remove the CHUTE TRANSFER (PL8.1.22) together with the BTR ASSY. (RRP8.11)
6) Remove the 150 FEEDER ASSY (PL5.1.1). (RRP5.1)
7) Disconnect the connector (P/J242) of the CLUTCH ASSY PH from the HARNESS ASSY TRAY 1
(PL5.1.37).
8) Remove the E-ring securing the CLUTCH ASSY PH, and remove the CLUTCH ASSY PH from the
SHAFT FEED (PL5.1.41).
9) Disconnect the connector (P/J243) of the CLUTCH REGI from the HARNESS ASSY TRAY 1.
10) Remove the E-ring securing the CLUTCH REGI, and remove the CLUTCH REGI from the ROLL
REGI METAL (PL5.1.34).
Replacement
The part names differ with the CLUTCH ASSY PH and CLUTCH REGI, but they are
the same parts.
1) Install the CLUTCH REGI to the ROLL REGI METAL (PL5.1.34), and secure it using the E-ring.
When installing, make sure that the notch of the CLUTCH REGI is combined with
the boss of the CHUTE REGI.
2) Connect the connector (P/J243) of the CLUTCH REGI (PL5.1.41) to the HARNESS ASSY TRAY 1
(PL5.1.37).
3) Install the CLUTCH ASSY PH to the SAHFT FEED, and secure it using the E-ring.
When installing, make sure that the notch of the CLUTCH ASSY PH is combined
with the boss of the CHUTE REGI.
The harness of the CLUTCH ASY PH should be one turned around the portion of
the CHUTE REGI as shown in the figure.
4) Connect the connector (P/J242) of the CLUTCH ASSY PH to the HARNESS ASSY TRAY 1.
5) Install the 150 FEEDER ASSY (PL5.1.1). (RRP5.1)
6) Install the CHUTE TRANSFER (PL8.1.22) together with the BTR ASSY. (RRP8.11)
Do not tighten the screw to the left side hole of the CHUTE TRANSFER.
7) Install the FAN MAIN (PL12.1.10). (RRP12.6)
8) Install the COVER REAR (PL1.1.3). (RRP1.1)
There are 2 kinds of screws, make sure they are put in the right place.
9) Install the FUSER ASSY (PL8.1.20). (RRP8.8)
10) Install the COVER REAR 500/COVER REAR 250 (PL10.2.21/PL9.1.12). (RRP10.9/9.4)
Chapter 3 Removal and Replacement Procedures (RRPs)
3 – 135