Oki B6200 Maintenance Manual page 496

Removal
1) Remove the COVER REAR 500/COVER REAR 250 (PL10.2.21/9.1.12). (RRP10.9/9.4)
2) Remove the COVER REAR (PL1.1.3). (RRP1.1)
3) Remove the COVER LEFT (PL1.1.6). (RRP1.3)
4) Remove the COVER RIGHT (PL1.1.4). (RRP1.2)
5) Remove the COVER EXIT 500 (PL10.1.1)/CHUTE ASSY EXIT 250 (Reference Only). (PL9.1.14)
(RRP10.1/9.7)
6) Remove the 500 EXIT ASSY (PL10.1.2)/CHUTE LW EXT2 ASSY (PL9.1.2). (RRP10.2/9.1)
7) Remove the COVER TOP (PL1.1.7). (RRP1.4)
8) Remove the COVER FRONT (PL1.1.5). (RRP1.5)
9) Remove the SHIELD PLATE LVPS (PL12.1.3). (RRP12.1)
10) Disconnect the harness connector from the connector (P/J101) on the PWBA EXIT MOTOR
(PL12.1.4).
11) Disconnect the harness connectors from the connectors (P/J40, P/J41, P/J42, P/J43, P/J44, P/
J45, P/J46, P/J47 and P/J48) on the LVPS.
12) Remove the 5 screws (silver, 6mm) securing the LVPS to the frame.
13) Remove the LVPS.
Replacement
1) Install the LVPS to the frame using the 5 screws (silver, 6mm).
2) Connect the harness connectors to the connectors (P/J40, P/J41, P/J42, P/J43, P/J44, P/J45, P/
J46, P/J47 andP/J48) on the LVPS.
3) Connect the connector of the harness LVPS to the connector (P/J101) on the PWBA EXIT MOTOR
(PL12.1.4).
4) Install the SHIELD PLATE LVPS (PL12.1.3). (RRP12.1)
5) Install the COVER FRONT (PL1.1.5). (RRP1.5)
6) Install the COVER TOP (PL1.1.7). (RRP1.4)
7) Install the 500 EXIT ASSY (PL10.1.2)/CHUTE LW EXT2 ASSY (PL9.1.2). (RRP10.2/9.1)
8) Install the COVER EXIT 500 (PL10.1.1)/CHUTE ASSY EXIT 250 (Reference Only). (PL9.1.14)
(RRP10.1/9.7)
When installing, pull the CHUTE EXIT FUSER lever.
9) Install the COVER RIGHT (PL1.1.4). (RRP1.2)
10) Install the COVER LEFT (PL1.1.6). (RRP1.3)
11) Install the COVER REAR (PL1.1.3). (RRP1.1)
There are 2 kinds of screws, make sure they are put in the right place.
12) Install the COVER REAR 500/COVER REAR 250 (PL10.2.21/9.1.12). (RRP10.9/9.4)
Chapter 3 Removal and Replacement Procedures (RRPs)
3 – 332