Oki B6200 Maintenance Manual page 306

Removal
1) Open the COVER OPEN (PL1.1.2).
2) Remove the COVER REAR 500/COVER REAR 250 (PL10.2.21/PL9.1.12). (RRP10.9/9.4)
3) Remove the FUSER ASSY (PL8.1.20). (RRP8.8)
4) Lift up the 150 FEEDER ASSY a little, insert a screwdriver through the space left by the FUSER
ASSY, and remove the screw (gold, 8mm) securing the HOLDER NO PAPER SENSOR
(PL5.1.39).
5) Remove the HOLDER NO PAPER SENSOR from the 150 FEEDER ASSY.
6) Release the hooks securing the SENSOR NO PAPER to the HOLDER NO PAPER SENSOR, and
remove the SENSOR NO PAPER.
7) Disconnect the HARNESS ASSY TRAY 1 (PL5.1.37) from the connector (P/J240) of the SENSOR
NO PAPER.
Replacement
1) Connect the connector (P/J240) of the HARNESS ASSY TRAY 1 (PL5.1.37) to the connector of
the SENSOR NO PAPER.
2) Install the SENSOR NO PAPER to the HOLDER NO PAPER SENSOR (PL5.1.39), and secure it
using hooks.
3) Put the wires of the HARNESS ASSY TRAY 1 into the notch of the HOLDER NO PAPER SENSOR
as shown in the figure.
4) Insert a screrwdriver through the space left by the FUSER ASSY, and install the HOLDER NO
PAPER SENSOR to the 150 FEEDER ASSY using the screw (gold, 8mm).
After tightening the screw, make sure that the wires of the HARNESS ASSY TRAY 1
have not pinched.
5) Install the FUSER ASSY (PL8.1.20). (RRP8.8)
6) Install the COVER REAR 500/COVER REAR 250 (PL10.2.21/PL9.1.12). (RRP10.9/9.4)
7) Close the COVER OPEN (PL1.1.2).
Chapter 3 Removal and Replacement Procedures (RRPs)
3 – 142