Oki B6200 Maintenance Manual page 293

Removal
1) Open the COVER OPEN (PL1.1.2).
2) While pressing down the boss of the HOLDER LEFT (PL5.1.5) at the back of the 150 FEEDER
ASSY, shift the HOLDER LEFT in the direction of the arrow to remove the 3 hooks.
3) Remove the HOLDER LEFT from the SUPPORT NUDGER (PL5.1.4). At the same time, the
ACTUATOR NO PAPER (PL5.1.6) is removed.
4) Release the hook of the ROLL ASSY NUDGER (PL5.1.11), and pull the ROLL ASSY NUDGER out
from the SHAFT NUDGER (PL5.1.9).
5) Release the hook of the GEAR NUDGER, and pull the GEAR NUDGER out from the SHAFT
NUDGER.
When removing, do not hold the rubber rollers of the ROLL ASSY NUDGER and
GEAR NUDGER.
Replacement
1) Install the GEAR NUDGER to the SHFT NUDGER (PL5.1.9), and secure the GEAR NUDGER with
the hook.
When installing, do not hold the rubber rollers of the ROLL ASSY NUDGER and
GEAR NUDGER.
Be sure to install the hook of the GEAR NUDGER into the groove of the SHAFT
NUDGER.
2) Install the ROLL ASSY NUDGER (PL5.1.11) to the SHFT NUDGER, and secure the ROLL ASSY
NUDGER with the hook.
Be sure to install the hook of the ROLL ASSY NUDGER into the groove of the
SHAFT NUDGER.
3) Install the HOLDER LEFT (PL5.1.5) and ACTUATOR NO PAPER (PL5.1.6) to the SUPPORT
NUDGER (PL5.1.4).
Be sure to install the shafts on both ends of the ACTUATOR NO PAPER into the
HOLDER LEFT and SUPPORT NUDGER.
Assemble the hook of the ACTUATOR NO PAPER to the HOLDER LEFT as shown
in the figure.
4) Move the HOLDER LEFT (PL5.1.5) in the opposite direction of the arrow, and secure it to the 150
FEEDER ASSY with the 3 hooks.
After installing, move the ACTUATOR NO PAPER with a finger, and make sure that
the ACTUATOR NO PAPER operates smoothly.
Chapter 3 Removal and Replacement Procedures (RRPs)
3 – 129