Oki B6200 Maintenance Manual page 413

Removal
1) Remove the COVER REAR 500/COVER REAR 250 (PL10.2.21/9.1.12). (RRP10.9/9.4)
2) Remove the COVER REAR (PL1.1.3). (RRP1.1)
3) Remove the FUSER ASSY (PL8.1.20). (RRP8.8)
4) Remove the COVER LEFT (PL1.1.6). (RRP1.3)
5) Remove the COVER RIGHT (PL1.1.4). (RRP1.2)
6) Remove the COVER EXIT 500 (PL10.1.1)/CHUTE ASSY EXIT 250 (Reference Only) (PL9.1.14).
(RRP10.1/9.7)
7) Remove the 500 EXIT ASST (PL10.1.2)/CHUTE LW EXT2 ASSY (PL9.1.2). (RRP10.2/9.1)
8) Remove the COVER TOP (PL1.1.7). (RRP1.4)
9) Remove the COVER FRONT (PL1.1.5). (RRP1.5)
10) Remove the BTR ASSY (PL8.1.21). (RRP8.10)
11) Remove the DUCT FRONT (PL8.1.4). (RRP8.2)
12) Remove the GUIDE ASSY CRU R (PL8.1.25). (RRP8.13)
13) Remove the 2 screws (gold tapping, 6mm) securing the PWBA ASSY ANT to the GUIDE ASSY
CRU R.
14) Remove the PWBA ASSY ANT.
15) Disconnect the harness connector from the connector (P/J150) on the PWBA ASSY ANT.
Replacement
1) Connect the harness connector to the connector (P/J150) on the PWBA ASSY ANT.
2) Install the PWBA ASSY ANT to the GUIDE ASSY CRU R (PL8.1.25) using the 2 screws (gold tap-
ping, 6mm).
3) Install the GUIDE ASSY CRU R (PL8.1.25). (RRP8.13)
4) Install the DUCT FRONT (PL8.1.4). (RRP8.2)
5) Install the COVER FRONT (PL1.1.5). (RRP1.5)
6) Install the COVER TOP (PL1.1.7). (RRP1.4)
7) Install the 500 EXIT ASST (PL10.1.2)/CHUTE LW EXT2 ASSY (PL9.1.2). (RRP10.2/9.1)
8) Install the COVER EXIT 500 (PL10.1.1)/CHUTE ASSY EXIT 250 (Reference Only) (PL9.1.14).
(RRP10.1/9.7)
9) Install the COVER RIGHT (PL1.1.4). (RRP1.2)
10) Install the COVER LEFT (PL1.1.6). (RRP1.3)
11) Install the FUSER ASSY (PL8.1.20). (RRP8.8)
12) Install the COVER REAR (PL1.1.3). (RRP1.1)
There are 2 kinds of screws, make sure they are put in the right place.
13) Install the COVER REAR 500/COVER REAR 250 (PL10.2.21/9.1.12). (RRP10.9/9.4)
14) Install the BTR ASSY (PL8.1.21). (RRP8.10)
Chapter 3 Removal and Replacement Procedures (RRPs)
3 – 249