Installing The Reservoir; Installing The Tilt Ram - SELVA MARINE Blue Whale 250 EFI Service Manual

NOTE:
Align the armature shaft with the recess in
the joint.
PTT motor mounting bolt 4:
19 N·m (1.9 kgf·m, 14.0 ft·lb)

Installing the reservoir

1. Install the spacer 1, filter 2 and sheet
3 to the PTT body.
2. Install the new O-ring 4 and reservoir
5, and then tighten the bolts 6 to the
specified torque.
3. Install the reservoir cap 7, and then
tighten it to the specified torque.
Reservoir mounting bolt 6:
19 N·m (1.9 kgf·m, 14.0 ft·lb)
Reservoir cap 7:
7 N·m (0.7 kgf·m, 5.2 ft·lb)

Installing the tilt ram

1. Fill the tilt cylinder with the recommended
fluid to the correct level a as shown.
2. Add a small amount of the recommended
fluid through the PTT body hole b as
shown.
6P23H11
Tilt cylinder and trim cylinder
3. Install the tilt piston assembly into the tilt
cylinder, and then tighten the tilt cylinder
end screw 1 to the specified torque.
NOTE:
Place the tilt cylinder end screw at the bottom
of the tilt ram a and install the tilt piston
assembly into the tilt cylinder.
Cylinder-end screw wrench:
90890-06568
Tilt cylinder end screw:
90 N·m (9.0 kgf·m, 66.4 ft·lb)
1
2
3
4
5
6
1
7
S6S17140
8
9
7-44