Main Switch; Power Trim And Tilt Switch On Remote Control Or Tiller Handle - SELVA MARINE MARLIN 100 EFI Owner's Manual

Basic components
EWM00120
WARNING
Attach the engine stop switch lanyard to
G
a secure place on your clothing, or your
arm or leg while operating.
Do not attach the lanyard to clothing
G
that could tear loose. Do not route the
lanyard where it could become entan-
gled, preventing it from functioning.
Avoid accidentally pulling the lanyard
G
during normal operation. Loss of engine
power means the loss of most steering
control. Also, without engine power, the
boat could slow rapidly. This could
cause people and objects in the boat to
be thrown forward.
NOTE:
The engine cannot be started with the lock
plate removed.
1. Lanyard
2. Lock plate
EMU26090

Main switch

The main switch controls the ignition system;
its operation is described below.
" " (off)
G
With the main switch in the "
tion, the electrical circuits are off, and the key
can be removed.
" " (on)
G
9
With the main switch in the "
the electrical circuits are on, and the key can-
not be removed.
"
G
With the main switch in the "
sition, the starter motor turns to start the en-
gine. When the key is released, it returns
automatically to the "
EMU26141
Power trim and tilt switch on remote
control or tiller handle
The power trim and tilt system adjusts the out-
board motor angle in relation to the transom.
Pressing the switch "
board motor up, then tilts it up. Pressing the
switch "
down and trims it down. When the switch is re-
leased, the outboard motor will stop in its cur-
rent position.
NOTE:
For instructions on using the power trim and
tilt switch, see pages 25 and 27.
" (off) posi-
" (start)
" (on) position.
" (up) trims the out-
" (down) tilts the outboard motor
" (on) position,
" (start) po-