Configuring Telnet Access; Configuring Ssh Access - HP ProCurve Secure Router 7203 dl Advanced Management And Configuration Manual

Configuring Telnet Access

After you configure an Ethernet interface and establish a connection to the
ProCurve Secure Router, you can configure Telnet access to the router.
Complete the following steps:
1. Establish a console session to the ProCurve Secure Router and move to
the global configuration mode context.
ProCurve# configure terminal
2. Enter the following command to access the Telnet line configuration
mode context:
Syntax: line telnet [0-4]
The ProCurve Secure Router supports five lines. Enter the number of the
line you want to configure. If you want to enable all five lines, enter:
ProCurve(configure)# line telnet 0 4
3. Create the Telnet password
Syntax: password [md5] <password>
Enter the md5 option to encrypt the password. Replace <password>
with an alphanumeric string of up to 16 characters.
For example, you might enter:
ProCurve(config-telnet0)# password md5 en$ter^tel
4. Exit to the global configuration mode context.
ProCurve(config-telnet0)# exit
5. Configure an enable mode password, if you have not done so already. The
enable mode password is required for Telnet access.
Syntax: enable password [md5] <password>
Enter the md5 option to encrypt the password. Replace <password>
with an alphanumeric string of up to 30 characters.

Configuring SSH Access

After you configure an Ethernet interface and establish a connection to the
ProCurve Secure Router, you can establish SSH access to the router. By
default, SSH access to the ProCurve Secure Router is enabled. After you have
set an enable mode password, you simply need to configure a username and
password.
Overview
Quick Start
1-29