Configuring A Spid And Ldn For Isdn Bri U Modules; Setting The Country For The Modem Interface - HP ProCurve Secure Router 7203 dl Advanced Management And Configuration Manual

Configuring Backup WAN Connections
Configuring Demand Routing for Backup Connections
N o t e
3-40
If you are configuring an ISDN line in North America, you may also need to
define a SPID. As described in the next section, you can set the SPID at the
same time that you set the LDN.

Configuring a SPID and LDN for ISDN BRI U Modules

Some North American telcos, principally those that use the ISDN switches
DMS-100 and National ISDN-1, issue a SPID, which is typically a 14-digit
number that includes the interface's 10-digit telephone or directory number
and a two- to four-digit identifier. This identifier specifies the type of service
on the line (data or voice). If the public carrier's switch requires a SPID, you
must specify it when you set up your ISDN equipment.
If you are configuring a router for an ISDN connection in North America, enter
the following command to set the SPID:
Syntax: isdn spid1 <SPID1>
Some public carriers assign two SPIDs to ISDN connections that use both
channels. You must set the second SPID in order for the second B channel to
properly receive data. You set the second SPID using the isdn spid2 com-
mand:
Syntax: isdn spid2 <SPID2>
You can set a SPID and an LDN in one command. Enter:
Syntax: isdn spid1 <SPID1> <LDN1>
For example, you might enter:
ProCurve(config-bri 1/3)# isdn spid1 70455511110101 5555551111
In North America, you can set LDNs using the isdn ldn1, isdn ldn2, isdn
spid1, or isdn spid2 commands. The router uses whatever LDN1 or LDN2
value that was most recently entered using these commands.

Setting the Country for the Modem Interface

Depending on what country your router is in, your modem may need to use
different signals to connect to the public carrier network. You must identify
the country for the analog module from the global configuration mode context:
Syntax: modem countrycode <country>