Configuring Mlfr - HP ProCurve Secure Router 7203 dl Advanced Management And Configuration Manual

Using the Web Browser Interface for Advanced Configuration Tasks
Increasing Bandwidth
14-20

Configuring MLFR

1. In the left navigation bar, select Physical Interfaces.
2. Choose the interface for the first physical carrier-line.
3. You will move to the physical interface's Configuration window. If you
have not already done so, configure the interface as described in "Config-
uring E1 and T1 Interfaces" on page 14-39 of the Basic Management and
Configuration Guide.
4. If you have not already done so, click the Encapsulation circle and select
Frame Relay.
5. Check the Multilink box.
6. A Frame Relay Multilink Interface section will display:
a. If you have already configured the Frame Relay interface for the
connection, chose Select. Choose the Frame Relay interface from the
pull-down menu.
b. If you have not configured the Frame Relay interface for the connec-
tion, chose New.
7. Click Apply.
8. The Frame Relay Configuration window will open. If you have not
already done so, configure the interface as described in "Configure Frame
Relay as the Data Link Layer Protocol" on page 14-52 of the Basic
Management and Configuration Guide. If you have not already done so,
you must establish at least one PVC.
9. Again select Physical Interfaces from the left navigation bar.
10. Choose the name of the interface for the second physical carrier-line. If
necessary, configure the interface as described in "Configuring E1 and T1
Interfaces" on page 14-39 of the Basic Management and Configuration
Guide.
11. Select Frame Relay for the Encapsulation and check the Multilink box.
12. In the Frame Relay Multilink Interface section, click Select. Choose the
same Frame Relay interface that you chose or configured in step 6.
13. Click Apply.
14. Repeat steps 8 through 12 for any additional carrier-lines.