Quick Start - HP ProCurve Secure Router 7203 dl Advanced Management And Configuration Manual

N o t e
Replace <listname> with the name of the ACL you want to debug.
For example, if you want to debug the Inside ACL, enter:
ProCurve# debug access-list Inside
To end the debug, enter one of the following commands:
Syntax: no debug access-list <listname>
Syntax: undebug all
The undebug all command ends all debug sessions on the ProCurve Secure
Router.
Debug commands are processor intensive and could compromise perfor-
mance.

Quick Start

This section provides the commands you will need to quickly configure and
apply access controls to interfaces on the ProCurve Secure Router. There are
two access control mechanisms on the ProCurve Secure Router:
access control lists (ACLs)
access control policies (ACPs)
ACLs can be used alone or in combination with ACPs. This "Quick Start"
section first explains how to use just ACLs to control access. Specifically, it
explains how to configure an ACL and apply it directly to an interface.
This section then outlines the steps for configuring an ACP. Specifically, it
explains:
how to configure an ACL
how to configure an ACP
how to apply the ACP to an interface
Only a minimal explanation is provided in the "Quick Start" section. For a
detailed explanation of ACLs and ACPs, read the entire chapter.
Applying Access Control to Router Interfaces
Quick Start
5-57