HP ProCurve Secure Router 7203 dl Advanced Management And Configuration Manual page 45

Overview
CLI Tools
To save a configuration as a file on compact flash, enter the following com-
mand from the enable mode context:
Syntax: copy flash <config-file> cflash <filename>
Replace <config-file> with either running-config or startup-config and
replace <filename> with a name that you choose.
Verify that the Percent Complete 100% message is displayed, indicating that
the download is complete. The current configuration is now saved in compact
flash with the specified filename.
To save a configuration as a file on internal flash, enter the following command
from the enable mode context:
ProCurve# copy <source file location> <source config-file> flash [<filename>]
Replace <source file location> with the location of the configuration file
you are saving. Replace <source config-file> with startup-config or run-
ning-config. You must enter a destination filename unless the filename will
be the same as that of the source. For example, if you need to save the startup-
config file from the compact flash card to internal flash, enter:
ProCurve# copy cflash startup-config flash startup-config
Saving the Current or Start-up Configuration to a TFTP Server. To
initiate an upload of a configuration file to an external TFTP server, enter one
of the following commands from the enable mode context:
ProCurve# copy [flash | cflash] tftp
ProCurve# copy [startup-config | running-config] tftp
For example, if you wanted to upload the startup-config on compact flash to
your TFTP server, you would enter:
ProCurve# copy cflash tftp
When prompted for the Address of remote host?, enter the IP address of
the TFTP server.
When prompted for the Source filename?, enter the name of the configura-
tion file (startup-config or running-config) you would like to upload.
When you are prompted for the Destination filename?, enter the filename
you'd like the uploaded configuration file to be named.
1-17