Configuring Session Timeouts - HP ProCurve Secure Router 7203 dl Advanced Management And Configuration Manual

Using the Web Browser Interface for Advanced Configuration Tasks
4. The default port for the SIP ALG is UDP 5060. If you so desire, you can
add protocol ports to the ALG. Enter the number of the UDP port in the
Port field of the Add SIP ALG Port section. Click Add Port.
5. The Reset button returns the ALGs to settings established the last time the
Apply button was clicked, not to default settings.
Figure 14-15. Enabling and Disabling ALGs

Configuring Session Timeouts

1. Select General Firewall under Firewall in the left navigation bar.
2. In the Firewall Configuration window, select the General Settings tab.
3. You can alter the settings for the default TCP, UDP, and ICMP timeouts.
These settings determine when the router will timeout any inactive TCP,
UDP, or ICMP session for which you do not set an override timeout (see
below). Enter the time in hours, minutes, and seconds in the fields to the
left of each label. See Figure 14-14 on page 14-24.
4. Click Apply.
Configuring the ProCurve Secure Router OS Firewall
14-25