Enabling Ip Services On The Router - HP ProCurve Secure Router 7203 dl Advanced Management And Configuration Manual

Using the Web Browser Interface for Advanced Configuration Tasks
5. The session software will display the CLI in the basic mode context. To
enter the enable mode context, enter enable. When the router prompts
you for the enable mode password, enter the password you configured.
From this Telnet session, you can configure the router using the CLI.

Enabling IP Services on the Router

In the IP Services section, you can enable or disable the router's Simple
Network Management Protocol (SNMP), FTP, TFTP, HTTP, HTTPS, and
Secure Copy servers. You can also configure settings for the Web browser
interface.
In addition to enabling these servers, you must configure passwords for them
so that users can access the router. To configure passwords for management
access, see "Configuring Passwords to Control Management Access to the
Router" on page 14-18 of the Basic Management and Configuration Guide.
1. Click System > IP Services in the left navigation bar. The IP Services
Enable/Disable window is displayed.
Enabling IP Services on the Router
14-15