Telnet To Unit - HP ProCurve Secure Router 7203 dl Advanced Management And Configuration Manual
Secure router
Hide thumbs
Also See for ProCurve Secure Router 7203 dl:
- Configuration manual (1114 pages) ,
- Reference manual (1455 pages) ,
- Product end-of-life disassembly instructions (2 pages)
Table of Contents
Advertisement
Using the Web Browser Interface for Advanced Configuration Tasks
Managing AutoSynchTM, Files, Firmware, and Boot Software
C a u t i o n
14-14
1.
Click the Save and Reboot button to save a copy of the current configura-
tion to a startup-config file. If you are running AutoSynch™, a copy is
saved to both internal flash and compact flash. This option allows you to
keep the current configuration and reboot the router.
If you have made changes to the Ethernet or WAN interface that you are using
to access the Web browser interface, or if you have made changes to any
security policies, saving and rebooting may lock you out of the router.
2.
Click the Reboot (Do Not Save) button to immediately reboot the router
without keeping any changes made to the configuration since the last
save. If you have made experimental changes to the router or if you have
made changes that are causing operation problems, you may want to
reboot the router and have it revert to a previous working configuration.
Telnet to Unit
The CLI allows you to configure more options. To open a Telnet session
between your router and your PC, select Telnet to Unit under Utilities in the
left hand navigation bar.
In order to successfully establish a Telnet session to your router, you first need
to configure the router to allow Telnet access.
1.
Set an enable mode password.
a.
On the left panel of the Web browser interface, click Passwords.
b. Scroll to the Service Authentication window and click the Enable tab.
c.
Select Use Password and enter an enable password. Enter the pass-
word again in the Confirm Password box.
d. Click Apply.
2.
Set a Telnet password.
a.
In the Service Authentication window, click the Telnet tab.
b. Select Use Password and enter the password in the box. Re-enter the
password in the Confirm Password box.
3.
In the left navigation bar, click Telnet to Unit. The PC will open a terminal
session and begin to establish a Telnet session.
4.
When the terminal session software begins, it will prompt you for a
password. Enter the Telnet password.
Advertisement
Chapters
Table of Contents
Troubleshooting
