Configuring Frame Relay Fragmentation; Configuring Qos On An Ethernet Interface - HP ProCurve Secure Router 7203 dl Advanced Management And Configuration Manual

Secure router
Hide thumbs Also See for ProCurve Secure Router 7203 dl:
Table of Contents

Advertisement

4.
If so desired, configure another entry to mark other packets.
5.
Assign the QoS map to the logical interface that transmits the packets:
ProCurve(config)# interface ppp 1
ProCurve(config-ppp 1)# qos-policy out <mapname>

Configuring Frame Relay Fragmentation

1.
Enable rate limiting on a PVC:
a.
Move to the Frame Relay subinterface for the PVC:
ProCurve(config)# interface frame-relay <subinterface number>
Set the committed burst rate:
Syntax: frame-relay bc <bps>
For example:
ProCurve(config-fr 1.101)# frame-relay bc 700000
b. Set the excessive burst rate:
ProCurve(config-fr 1.101)# frame-relay be 400000
Syntax: frame-relay be <bps>
2.
Enable Frame Relay fragmentation for the PVC and set the fragment size:
Syntax: frame-relay fragment <bytes>
The threshold for fragmenting frames can be between 64 and 1600 bytes.
For example, enter:
ProCurve(config-fr 1.101)# frame-relay fragment 210

Configuring QoS on an Ethernet Interface

1.
Move to the Ethernet interface configuration mode context and enable
rate limiting:
Syntax: traffic-shape rate <bps>
2.
If you want the Ethernet interface to implement CBWFQ or low-latency
queues, configure the QoS map as described above.
3.
Apply the QoS map to the Ethernet interface. From the Ethernet interface
configuration mode context, enter:
Syntax: qos-policy out <mapname>
Setting Up Quality of Service
Quick Start
7-73

Advertisement

Table of Contents
loading

This manual is also suitable for:

Procurve secure router 7102 dl

Table of Contents