Selecting A Rip Version - HP ProCurve Secure Router 7203 dl Advanced Management And Configuration Manual

Options RIP Specification
which routers send • all router interfaces on RIP
and receive updates
• passive interfaces, which
when routers send • every update interval
and receive updates
• immediately after a change
metric computation • number of hops to the
and route selection
• redistributed routes are
To configure RIP on the ProCurve Secure Router, you must:
select a version
specify the networks that will participate in RIP
You can also configure the following to tailor RIP for a specific network:
redistribute connected, static, and OSPF routes into the RIP routing table
enable route summarization
configure passive interfaces to filter RIP messages
alter RIP intervals
You enter most RIP configuration commands from the RIP configuration mode
context. You configure the RIP version that a particular interface sends and
receives from that (logical) interface's configuration mode context.
From the global configuration mode context, enter the following command to
access the RIP configuration mode context:
ProCurve(config)# router rip
ProCurve(config-rip)#

Selecting a RIP Version

You must select a global RIP version. If necessary, you can also override this
version for particular interfaces.
IP Routing—Configuring RIP, OSPF, BGP, and PBR
networks
receive updates but do not
send them
in network topology
(triggered updates)
destination
assigned a default metric
Configuring RIP
Configuration Considerations
• specifying RIP networks
(page 13-21)
• configuring passive
interfaces (page 13-26)
altering RIP intervals (page
13-28)
altering the default metric for
redistributed routes (page 13-22)
13-19