HP ProCurve Secure Router 7203 dl Advanced Management And Configuration Manual page 857

Using the Web Browser Interface for Advanced Configuration Tasks
Figure 14-42.Marking Packets with a ToS Value
4. Move to the Packet Marking window. Enter the value with which the
router should mark packets:
a. Select DSCP to enter a DiffServ value between 0 and 63.
b. Select Precedence to enter an IP precedence value between 0 and 7.
5. Only set a maximum bandwidth if you want to place the marked traffic in
a low latency queue. See "Configuring LLQ" on page 14-53. If you want the
QoS map entry only to mark packets select Disable under Priority Queue
(see figure 14-42).
6. Click Apply.
7. If necessary repeat steps 2 through 6 to configure more map entries. For
each set of traffic to be marked on the same interface, give the entry the
same name but a different number. The router processes map entries in
order starting with the lowest. (You can also apply LLQ to the same
interface by configuring new map entries with the same name.)
Figure 14-43. Applying a QoS Policy to an Interface
Configuring Quality of Service
14-57