HP ProCurve Secure Router 7203 dl Advanced Management And Configuration Manual page 382

Setting Up Quality of Service
Quick Start
N o t e
7-70
5. Match the entry to the criterion for the class with one of the commands
shown in Table 7-14.
For example:
ProCurve(config-qos-map)# match list Network1
Table 7-14. QoS Map Criteria
Criteria
ToS value—IP precedence
ToS value—DiffServ
IP header—source or destination
IP address and protocol port
destination UDP real-time
protocol (RTP) port
bridged traffic
6. Set the bandwidth for the class as an absolute value, a percentage, or a
percentage of bandwidth remaining after low latency queues have been
served:
Syntax: bandwidth [<Kbps> | percent <percentage> | remaining percent <per-
centage>]
For example:
ProCurve(config-qos-map)# bandwidth remaining percent 15
Percentages must be whole values. You can reserve up to 75 percent of
the interface's total or rate-limited bandwidth for CBWFQ classes.
The range for absolute bandwidth is 8 to 200,000 Kbps. However, you are
still limited to 75 percent of the interface's physical access rate or rate-
limited rate.
7. Configure another class by repeating steps 3 through 5. If you want to
establish low-latency queues as well, configure them as described on page
7-71. Assign each QoS map entry the same name but a different number.
For example:
ProCurve(config)# qos map Class 20
QoS map names are case-sensitive.
Match Command
match precedence <0-7>
match dscp <0-63>
match list <ACL listname>
match ip rtp <first port number> [<last port number>] [all]
match protocol bridge [netbeui]