Mlppp Configuration - HP ProCurve Secure Router 7203 dl Advanced Management And Configuration Manual

Increasing Bandwidth
Quick Start
2-20

MLPPP Configuration

Before you begin completing these instruction, you should connect the phys-
ical interfaces to the appropriate public carrier equipment. You should also
have a non-multilink PPP connection up and running.
1. Move to the global configuration mode context and configure the physical
interface(s) for the new carrier line(s):
a. Move to the interface configuration mode context:
Syntax: interface [e1 | t1] <slot>/<port>
b. TDM group numbers are significant for the interface only, so you can
use the same TDM group number as the original line. You must use
the same number of channels:
Syntax: tdm-group <tdm group number> timeslots <channels>
For example, you might enter:
ProCurve(config-e1 1/2)# tdm-group 1 timeslots 1-31
c. Activate the interface:
ProCurve(config-e1 1/2)# no shutdown
d. Repeat these steps for each new carrier line.
2. Move to the PPP interface for the connection:
Syntax: interface ppp <interface number>
3. Enable multilink functions:
ProCurve(config-ppp 1)# ppp multilink
4. Bind each new physical interface to the PPP interface:
Syntax: bind <bind number> [e1 | t1] <slot>/<port> <tdm group number> ppp
<interface number>
Use a different bind number for each physical interface. For example, you
might enter:
ProCurve(config-ppp 1)# bind 2 e1 1/2 1 ppp 1
ProCurve(config-ppp 1)# bind 3 e1 2/1 1 ppp 1