Viewing Acls And Acps - HP ProCurve Secure Router 7203 dl Advanced Management And Configuration Manual

Configuring Network Address Translation

Viewing ACLs and ACPs

N o t e
6-16
Viewing ACLs and ACPs
After you configure NAT on the ProCurve Secure Router, you can use show
commands to:
view ACLs configured to select the traffic for NAT
view NAT entries in ACPs
display information about connections associated with particular ACPs
The show commands related to ACLs and ACPs are listed in Table 6-5.
Table 6-5. show Commands for ACLs and ACPs
Command
show access-lists
show ip access-lists
show ip policy-class
show ip policy-sessions
show ip policy-sessions [all
| <policyname>]
show ip policy-stats
You enter show commands from the enable mode context. If you are in a
different context (other than the basic mode context), you can use the do
command. For example:
ProCurve(config)# do show ip access-lists
Explanation
displays all of the ACLs configured on the ProCurve Secure
Router
displays all of the IP-based ACLs configured on the ProCurve
Secure Router
displays all of the ACPs configured on the ProCurve Secure
Router
displays the total number of sessions (connections) associated
with ACPs, the number of sessions per ACP, and detailed
information about each device that has established a session
displays all of the sessions or the sessions associated with the
specific ACP and detailed information about each device that
has established a session
displays information related to ACPs, such as the number of
current sessions and the maximum number of sessions
allowed