HP ProCurve Secure Router 7203 dl Advanced Management And Configuration Manual page 592

Configuring Multicast Support with PIM-SM
Troubleshooting PIM-SM
11-64
RouterA# show ip pim-sparse rp-set
Group address Static-RP-address
-----------------------------------
rp1
rp2
rp3
RouterA# show access-lists
Standard IP access list rp1
permit host 239.255.255.1 (1 matches)
Standard IP access list rp2
deny host 239.255.255.1 (1 matches)
permit 224.0.0.0 15.255.255.255 (3 matches)
permit 224.0.0.0 7.255.255.255 (0 matches)
Standard IP access list rp3
deny host 239.255.255.1 (0 matches)
permit 232.0.0.0 7.255.255.255 (1 matches)
Figure 11-30. Viewing an RP Set That Associates Different RPs with Different
Groups
In this example, Router 10.1.1.1 supports a single multicast group with the IP
address 239.255.255.1. Router 10.1.1.2 supports all multicast groups except
239.255.255.1. Router 10.3.3.2 supports the second half of all multicast groups
(232.0.0.0 through 239.255.255.255) except group 239.255.255.1.
The RP set for the upstream router is shown in Figure 11-31.
RouterB# show ip pim-sparse rp-set
Group address Static-RP-address
-----------------------------------
rp1
rp2
rp3
ProCurveSR7203dl# show access-lists
Standard IP access list rp1
permit host 239.255.255.1 (1 matches)
Standard IP access list rp2
deny host 239.255.255.1 (1 matches)
permit 224.0.0.0 7.255.255.255 (2 matches)
Standard IP access list rp3
deny host 239.255.255.1 (0 matches)
permit 232.0.0.0 7.255.255.255 (2 matches)
Figure 11-31. Comparing RP Sets
10.1.1.1
10.1.1.2
10.3.3.2
10.1.1.1
10.1.1.2
10.3.3.2
This ACL is different
than the ACL
configured for
Router 10.1.1.2 on
Router A.