Specify The Order In Which Connect Sequences Are Used; Configure The Number Of Connect Sequence Attempts - HP ProCurve Secure Router 7203 dl Advanced Management And Configuration Manual

Specifying the busyout-threshold <value> is optional. Include a value
between 1 and 65535 to specify the maximum number of times the ProCurve
Secure Router will try this connect sequence. If you specify 0, the ProCurve
Secure Router will make an unlimited number of attempts. If you specify any
other number, the ProCurve Secure Router will skip this connect sequence
after it reaches the maximum number. (Depending on your configuration, the
ProCurve Secure Router may cycle through the list of connect sequences more
than once in its attempt to establish a connection. For more information, see
"Configure the Number of Connect Sequence Attempts" on page 3-30.)
There is no default connect sequence. If you do not enter a connect-sequence
command, the demand interface will not be able to originate a backup
connection.
Deleting a Connect Sequence. To delete a connect sequence entry, enter:
ProCurve(config-demand 1)# no connect-sequence <sequence-number>

Specify the Order in Which Connect Sequences Are Used

If you configure more than one connect sequence, you can configure the order
in which each one is used. From the demand interface configuration mode
context, enter:
Syntax: connect-order [sequential | last-successful | round-robin]
Table 3-5 lists each option with a brief description.
Table 3-5. Options for Processing the Connect Sequences
Option Description
sequential Process each connect sequence in numerical order, starting with the
lowest number and ending with the highest number.
last-successful Process the last-successful connect sequence first. If that connect
sequence is not successful, process those remaining in numerical order,
starting with the lowest number and ending with the highest number.
round-robin First, process the connect sequence that follows the last-successful
connect sequence. (If no connection has been made, process the first
connect sequence.)
The default setting is sequential. To return the connect-order to the default
setting, enter:
ProCurve(config-demand 1)# no connect-order
Configuring Backup WAN Connections
Configuring Demand Routing for Backup Connections
3-29