Configuration - HP ProCurve Secure Router 7203 dl Advanced Management And Configuration Manual

Using the Web Browser Interface for Advanced Configuration Tasks
The AutoSynch Status window displays AutoSynch™ messages, such as the
current synchronization status of the SROS file (SROS.BIZ) and startup-
config file and any AutoSynch™ error messages. For a list of AutoSynch™
error messages and troubleshooting methods, see "AutoSynch™ Technol-
ogy" on page 1-34 in the Basic Management and Configuration Guide.

Configuration

The configuration section supports basic configuration file management.
Startup-Config. The Startup-Config section allows you to set the primary
and secondary startup-config files. The startup-config file contains your
router's saved configurations. If you have more than one startup configuration
on internal flash or compact flash, you can set the router to boot from the file
and the location you specify.
Figure 14-2. Startup Config window
After the ProCurve Secure Router boots the SROS software, it then searches
for a configuration to load. By default, the router first looks on compact flash
for a valid startup-config file. If it cannot find a valid startup-config on compact
flash, it looks on the internal flash memory for a valid file. You can configure
the router to load a different configuration by specifying this configuration's
filename and location.
1. Select the primary startup-config file from the pull-down menu. This menu
contains a list of configuration files on the internal flash memory (and
compact flash if installed).
Managing AutoSynchTM, Files, Firmware, and Boot Software
14-7