Backing Up A Connection With An Analog Module - HP ProCurve Secure Router 7203 dl Advanced Management And Configuration Manual

Enter times in 24-hour clock format. For example:
ProCurve(config-fr 1.102)# no backup schedule saturday
ProCurve(config-fr 1.102)# backup schedule disable-time 18:00:00
ProCurve(config-fr 1.102)# backup schedule enable-time 8:00:00
14. If you are using static routing, add a floating static route to the remote site.
Syntax: ip route <remote network A.B.C.D> [<remote subnet mask> | /<prefix
length>] [<remote backup A.B.C.D> | ppp <backup interface number>] [<admin-
istrative distance>]
Set the administrative distance higher than the route through the primary
connection so that the router will only add the backup route to its table
if the primary connection fails. For example, enter:
ProCurve(config)# ip route 192.168.3.0 /24 ppp 2 2

Backing up a Connection with an Analog Module

1. Install the backup module. Refer to the "Installation Instructions" in the
ProCurve Secure Router dl Analog Backup Module Quick Start Guide.
2. Power up the router and move to the global configuration mode context.
If the router is in any country except the USA or Canada, specify the
country. (Use the ? help command to get a list of the keywords for
countries.)
Syntax: modem countrycode <country>
3. Enter the modem interface configuration mode context.
Syntax: interface modem <slot>/<port>
4. Activate the interface.
ProCurve(config-modem 1/3)# no shutdown
5. Create a backup PPP interface.
Syntax: interface ppp <backup interface number>
6. Assign the backup interface an IP address on a different network than the
primary interface.
Syntax: ip address <backup A.B.C.D> <subnet mask | /prefix length>
7. Activate the interface.
ProCurve(config-ppp 2)# no shutdown
Configuring Backup WAN Connections
Quick Start
3-107