HP ProCurve Secure Router 7203 dl Advanced Management And Configuration Manual page 799

N o t e
8. Apply the route map to LAN interfaces to enable PBR for traffic outbound
to the WAN. (This is the typical application.) You can also apply route
maps to any logical interface. Move to the Ethernet or logical interface
configuration mode context and enter this command:
Syntax: ip policy route-map <mapname>
An interface must have an IP address in order for you to assign a route map
to it.
IP Routing—Configuring RIP, OSPF, BGP, and PBR
Quick Start
13-185