Viewing Lldp Timers - HP ProCurve Secure Router 7203 dl Advanced Management And Configuration Manual

ProCurve# debug lldp tx verbose
LLDP: TTL 120
LLDP: System Description "ProCurve Secure Router 7203dl"
LLDP: System Name "ProCurve"
LLDP: System Description "ProCurve Secure Router 7203dl, Version:
03.01, Date: Fri Aug 12 08:41:29 2005"
LLDP: System Capabilities:
LLDP: Bridge, Router
LLDP: Enabled System Capabilities:
LLDP: Router
LLDP: Management Address:
LLDP: Type: "IP version 4"
LLDP: Interface Type: "Interface Index" Id: 13
LLDP: OID: "1.3.6.1.2.1.2.2.1.1.13"
LLDP: Next Update for eth 0/1 in 30 second
Figure 12-7. Debugging LLDP Messages

Viewing LLDP Timers

You can view the global settings for LLDP timers by entering this enable mode
command:
Syntax: show lldp
The CLI displays:
how often LLDP messages are sent
how often TTL updates are sent
You can change how often LLDP messages are sent by changing the transmit
interval and minimum transmit interval. You cannot directly change the TTL.
Instead, you must change the TTL multiplier, which determines for how many
transmit intervals a message is stored. The TTL is the transmit interval
multiplied by the TTL multiplier.
See "Altering LLDP Timers" on page 12-14 to learn more about altering timers.
Link Layer Discovery Protocol
Viewing LLDP Information
Address: "192.168.1.1"
12-11