HP ProCurve Secure Router 7203 dl Advanced Management And Configuration Manual page 676

IP Routing—Configuring RIP, OSPF, BGP, and PBR
Configuring OSPF
Total stub area 5
.5
Router B
192.168.251.5
Site B
10.1.6.0 /24
13-62
10.1.5.0 /24
.2
.5
ABR
192.168.254.2
Router A
192.168.252.4
10.1.7.0 /24
Figure 13-14. Example OSPF Configuration
To configure the ABR, you would complete the following steps:
1. Assign IP addresses to the Ethernet and WAN interfaces:
ProCurve(config)# interface eth 0/1
ProCurve(config-eth 0/1)# ip address 10.1.1.2 /24
ProCurve(config)# interface eth 0/2
ProCurve(config-eth 0/2)# ip address 10.1.3.2 /24
ProCurve(config)# interface ppp 1
ProCurve(config-ppp 1)# ip address 10.1.4.2 /24
ProCurve(config)# interface ppp 2
ProCurve(config-ppp 2)# ip address 10.1.5.2 /24
2. Define the router ID by configuring a loopback interface:
ProCurve(config)# interface loop 1
ProCurve(config-loopback 1)# ip address 192.168.254.2 /24
3. Access the OSPF configuration mode context:
ProCurve(config)# router ospf
Area 0
Internal Router
192.168.253.3
.3
10.1.3.0 /24
10.1.1.0 /24
.2
.2
.2
10.1.4.0 /24
.4
.4
Stub
area 4
Site A
10.1.8.0 /24
.3
10.1.2.0 /24
ASBR
.1
.1
192.168.255.1
.1
10.200.1.0 /24
RIP
network