Quick Start - HP ProCurve Secure Router 7203 dl Advanced Management And Configuration Manual

Interval Meaning
transmit interval time between sending
LLDP messages during
normal operations
minimum transmit minimum time the
interval interface must wait
before sending a new
LLDP message
ttl multiplier number of transmit
intervals information
should be stored
reinitialization delay time an interface must
wait to send an LLDP
message after LLDP is
re-enabled
Table 12-2. LLDP Intervals
Default
30 seconds
2 seconds
4
2 seconds

Quick Start

All Ethernet and logical interfaces on the ProCurve Secure Router, except
ATM subinterfaces, automatically run LLDP. Typically, you do not need to
change any configurations.
This section provides the commands you must enter to quickly:
disable LLDP on a specific interface
disable an interface from sending specific types of information about the
router
view information about LLDP neighbors
Only a minimal explanation is provided. If you need additional information
about any of these options, check "Contents" on page 12-1 to locate the section
that contains the explanation you need.
1. You can disable LLDP on a specific interface. Move to its configuration
mode context and enter one or more of these commands:
a. To disable LLDP entirely, enter:
Syntax: no lldp send-and-receive
Link Layer Discovery Protocol
Range Command Syntax
5 to 32,768 seconds lldp transmit-interval
<seconds>
1 to 8192 lldp minimum-
transmit-interval
<seconds>
2 to 10 lldp ttl-multiplier
<value>
1 to 10 seconds lldp reinitialization-
delay <seconds>
Quick Start
12-15