HP ProCurve Secure Router 7203 dl Advanced Management And Configuration Manual page 44

Overview
CLI Tools
1-16
This command is used to copy and save files in the router's internal flash and
compact flash memories. Table 1-2 gives the available options for the copy
command.
You can also use this command to save the changes you make in the running-
config to the startup-config. If you do not save these changes, the next time
the router reboots, any changes will be lost.
To save configuration changes while using the CLI, enter:
Syntax: copy running-config [<destination location> <destination filename> |
<config-file>]
ProCurve# copy running-config startup-config
Table 1-2. Options for the copy Command
Source Location Options
cflash <filename> or
flash <filename>
cflash or flash
console
running-config
startup-config
tftp or xmodem
Verify that the Done. Success! message is displayed, indicating that the copy
process is complete.
Destination Location Options
• boot
• cflash [<filename>]
• flash [<filename>]
• interface (only from flash <filename>)
• tftp
• xmodem
• flash <filename>
• cflash <filename>
• flash <filename>
• startup-config
• tftp
• xmodem
• cflash <filename>
• flash <filename>
• running-config
• tftp
• xmodem
• flash
• cflash
• running-config
• startup-config