HP ProCurve Secure Router 7203 dl Advanced Management And Configuration Manual page 937

8. Configure the ADSL interface for the connection between Berlin and
Mannheim.
Berlin(config)# interface adsl 2/1
Berlin(config-adsl 2/1)# training-mode multi-mode
Berlin(config-adsl 2/1)# snr-margin 6
Berlin(config-adsl 2/1)# no shutdown
Berlin(config-adsl 2/1)# retrain
9. Configure the Data Link Layer protocols for the ADSL connection. In this
example, the ADSL line operates using PPPoE. (For more information on
configuring PPPoE for an ADSL connection, see the Basic Management
and Configuration Guide, Chapter 7: ADSL WAN Connections.) Config-
ure PPPoE by entering the following:
a. Create and activate an ATM interface.
Berlin(config-adsl 2/1)# interface atm 1
Berlin(config-atm 1)# no shutdown
b. Create and configure an ATM subinterface. Enter:
Berlin(config-atm 1)# interface atm 1.1
Berlin(config-atm 1.1)# pvc 0/33
Berlin(config-atm 1.1)# encapsulation aal5snap
Berlin(config-atm 1.1)# atm routed-bridged ip
Berlin(config-atm 1.1)# description Connection to Mannheim
Berlin(config-atm 1.1)# no shutdown
c. Bind the ADSL interface to the ATM interface.
Berlin(config-atm 1.1)# bind 4 adsl 2/1 atm 1
d. Create and activate a PPP interface.
Berlin(config-atm 1.1)# interface ppp 2
Berlin(config-ppp 2)# ip address 10.1.2.50 /24
Berlin(config-ppp 2)# no shutdown
e. Bind the ATM subinterface to the PPP interface and designate the link
as a PPPoE connection.
Berlin(config-ppp 2)# bind 5 atm 1.1 ppp 2 pppoe-client
10. Configure the backup connection for the ADSL line.
a. Configure and activate the backup module, which is located over the
ADSL module.
Berlin(config-ppp 2)# interface bri 2/2
Berlin(config-bri 2/2)# isdn ldn1 496211111111
Berlin(config-bri 2/2)# no shutdown
Appendix A: Example Configuration
Configuring the Physical and Data Link Layers
A-9