HP ProCurve Secure Router 7203 dl Advanced Management And Configuration Manual page 892

Using the Web Browser Interface for Advanced Configuration Tasks
Setting Up Virtual Private Networks
14-92
Figure 14-68. Adding a Remote ID
5. The field below is altered according to the ID type that you select. You
enter the peer's identification information in this field. For example, in
figure 14-68 the Remote ID Type is Domain Name, so the field becomes
the Domain Name field. You can enter *.procurve.com to allow any device
with a domain name ending in procurve.com to access the VPN.
6. If your VPN uses preshared keys for authentication, enter the key in the
Preshared Key field.
7. If this remote ID is for mobile peers, you should check the Use Mode
Config box. See steps 8 through 11 in "Client-to-Site Configuration" on
page 14-78 to learn how to configure an IKE mode config pool for a client-
to-site VPN connection.