HP ProCurve Secure Router 7203 dl Advanced Management And Configuration Manual page 54

Overview
Managing Configuration Files Using a Text Editor
1-26
Figure 1-5. Using Boot Error Messages to Target a Configuration Problem
The line number given in the error message is the line number in the running-
config. You can use this information to repair any configuration problems.
You will need to scroll up in your terminal session software window to read
the error message. Make a note of the reported line number, the command,
and the resulting error message, as shown in Figure 1-5. Then return to the
command line and enter the enable mode context.
Enter show running-config to display the current configuration. When the
running-config is displayed, begin with the first exclamation point and count
down, line by line, until you reach the line that generated the error message.
Check the resulting message from the error report. Repair the problem by re-
entering the command on that line using the error report as a guide.
For example, in Figure 1-5, there is an error in line 58. The faulty command was
ProCurve(config-ike)# peer 10.2.2.1
The peer at 10.2.2.1 was already assigned to IKE policy 100 and cannot be
assigned to more than one policy. In this example, the IKE policy configura-
tions may need to be adjusted.
Error location
Resulting
message