HP ProCurve Secure Router 7203 dl Advanced Management And Configuration Manual page 855

Using the Web Browser Interface for Advanced Configuration Tasks
e. To place bridged packets in a queue, select Bridged.
f. NetBIOS Extended User Interface (NetBEUI) allows hosts to commu-
nicate within the LAN. To place only NetBEUI bridged packets in the
queue, select NetBEUI.
Figure 14-41.Setting the Maximum Bandwidth Guaranteed to a Queue
4. In the Priority Queue section, select Bandwidth and enter the maximum
transmission rate guaranteed to the queue in the Limit field. (Traffic can
burst past this rate.) Enter the rate in Kbps.
You can optionally specify a maximum burst rate in the Burst field.
However, you should almost always leave the burst value at the default.
To guarantee the queue all the bandwidth it needs, select Unlimited
bandwidth. Be very careful with this option as it will starve out all other
traffic.
5. Click Apply.
6. You also can mark packets in the queue with a ToS value. See "Configuring
Packet Marking" on page 14-56.
7. If necessary repeat steps 2 through 6 to configure more map entries. For
queues that will be applied to the same interface, give each entry the same
name but different number.
Configuring Quality of Service
14-55