Quick Start - HP ProCurve Secure Router 7203 dl Advanced Management And Configuration Manual

If the table does not exist, multicast routing may not be enabled. You must
enable multicast routing in order for downstream interfaces to forward
multicast messages. Enter:
ProCurve(config)# ip multicast-routing
Make sure that you have configured an upstream interface. View the
portion of the running config for the upstream interface (for example,
enter show run int ppp 1) and look for ip mcast-stub upstream.

Quick Start

This section provides the commands you must enter to quickly configure
support for multicasting.
Only a minimal explanation is provided. If you need additional information
about any of these options, check "Contents" on page 10-1 to locate the section
that contains the explanation you need.
If you so choose, you can print and fill out Table 10-3 with information for your
network. You can then use this worksheet to complete the quick start com-
mands.
Table 10-3. Multicast Settings
Information Required
multicast router (helper
address)
downstream interfaces
Configuring Multicast Support for a Stub Network
Setting
IP address
interface ID:
• Ethernet interface
– <slot>
– <port>
• WAN interface:
– <interface type>
– <interface number>
Quick Start
Your Setting
10-23