Autosynch; Troubleshooting Commands; Reload In - HP ProCurve Secure Router 7203 dl Advanced Management And Configuration Manual

Overview
CLI Tools

autosynch

The autosynch command is used with a compact flash card. Enabling the
AutoSynch™ function allows the router to automatically keep the startup-
config and SROS files in internal flash synchronized with the startup-config
and SROS file on the compact flash card.
The autosynch command is disabled in its default setting. To enable the
AutoSynch™ technology, enter the global configuration mode and enter:
ProCurve (config)# autosynch-mode
AutoSynch: SROS.BIZ synched
AutoSynch: startup-config synched
To disable AutoSynch™, use the no command:
ProCurve(config)# no autosynch-mode
AutoSynch: SROS.BIZ not synched
AutoSynch: startup-config not synched
For more information on file management and router boot functioning, please
see the Basic Management and Configuration Guide, Chapter 1: Overview.

Troubleshooting Commands

The following commands are some basic commands to help with trouble-
shooting router operation.

reload in

When you are configuring the ProCurve Secure Router through a Telnet, SSH,
or Web session, you may want to enter a safeguard to ensure that you do not
inadvertently block your access to the router. You can configure the ProCurve
Secure Router to reload the startup-config at a specified future time, returning
the router to its previous configurations.
To schedule a system reboot, enter the following command from the enable
mode context:
ProCurve# reload in <mmm>
or
ProCurve# reload in <hhh:mm>
1-19