HP ProCurve Secure Router 7203 dl Advanced Management And Configuration Manual page 180

Configuring Backup WAN Connections
Quick Start
3-100
Table 3-21 lists the command syntax for each signaling type.
Table 3-21. ISDN Signaling Types
Signaling Type
National ISDN-1
Euro ISDN
Northern Telecom DMS-100
Lucent/ATT 5ESS
c. Set the LDN. (If your public carrier has assigned you a SPID, skip this
step and go to the next step.) Otherwise, enter:
Syntax: isdn ldn1 <number>
Replace <number> with the LDN phone number assigned to the
ISDN line you are configuring. For example, you might enter:
ProCurve(config-bri 1/1)# isdn ldn1 5555551212
d. If your public carrier has assigned you a SPID, you should set the SPID
and the LDN at the same time. Enter:
Syntax: isdn spid1 <number> <ldn1>
For example, you might enter:
ProCurve(config-bri 1/1)# isdn spid1 12355512120101 5551212
e. Make the BRI interface a member of the resource group:
Syntax: resource pool-member <poolname>
For example, if you want to assign the BRI interface to a resource
pool called "backup," enter:
ProCurve(config-bri 1/1)# resource pool-member Backup
f. Activate the interface. Enter:
ProCurve(config-bri 1/1)# no shutdown
5. Create a floating static route to the far-end network. The route should use
the demand interface as the forwarding interface. From the global config-
uration mode context, enter:
Syntax: ip route <destination A.B.C.D> <subnet mask | /prefix length> demand
<number> [<administrative distance>]
Command Syntax
isdn switch-type basic-ni
isdn switch-type basic-net3
isdn switch-type basic-dms
isdn switch-type basic-5ess