Configuring A Modem Interface (Analog Only) - HP ProCurve Secure Router 7203 dl Advanced Management And Configuration Manual

The txadd-timer command specifies the length of time the router will wait
for additional calls to be connected before deciding that the bonding call has
failed. When dialing overseas, you should enter a value above 60 seconds to
allow for slower call routing.
Syntax: bonding txadd-timer <seconds>
The txcid-timer command sets the maximum amount of time the router will
take to negotiate data rates and channel capacities for the bearer channels.
Syntax: bonding txcid-timer <seconds>
When multiple calls are being aggregated, the calls may be routed through
different devices within the public carrier's infrastructure. This can create a
delay between the two calls.
The txdeq-timer command sets a maximum amount of time for the router to
take when equalizing the delay between the two calls that are being bonded.
Syntax: bonding txdeq-timer <seconds>
The txfa-timer command specifies the length of time the originating and
answering routers spend attempting to detect the bonding frame pattern when
a call is connected.
Syntax: bonding txfa-timer <seconds>
The txinit-timer option sets the time the originating router waits to detect
the bonding negotiation frame pattern when a call is connected.
Syntax: bonding txinit-timer <seconds>
The txnull-timer command specifies the time the answering router takes
attempting to detect the bonding negotiation pattern from the originating
router. It may be necessary to shorten this timer if the DTE equipment using
the bonding module also has timer constraints for negotiating a non-bonding
parameter.
Syntax: bonding txnull-timer <seconds>

Configuring a Modem Interface (Analog Only)

To configure a modem interface, you must:
identify your country
activate the interface
Configuring Backup WAN Connections
Configuring a Persistent Backup Connection
3-51