Quick Start; Accessing The Secure Router Os - HP ProCurve Secure Router 7203 dl Advanced Management And Configuration Manual

Quick Start

This section provides the instructions you need to quickly access the ProCurve
Secure Router CLI and configure an enable mode password to protect the
router from unauthorized access. This section also explains how to configure
the Ethernet interface and the HTTP server so that you can access the Web
browser interface. You will then be able to manage the ProCurve Secure
Router through an Internet browser.
Only minimal explanation is provided. It is strongly recommended that you
read the entire chapter so that you understand how the Secure Router oper-
ating system (OS) is organized and how to manage the OS. If you need
information about a specific aspect of managing the OS, see the Basic Man-
agement and Configuration Guide to locate the section that contains the
explanation you need.

Accessing the Secure Router OS

1. Use the serial cable (5184-1894) that shipped with the ProCurve Secure
Router to connect the COM port on your laptop to the console port on the
front panel of the router.
2. Open a terminal session with the ProCurve Secure Router, using the
following settings:
• Baud Rate = 9600
• Parity = None
• Data Bits = 8
• Stop Bits = 1
• Flow Control = None
3. Press to access the basic mode context.
Enter
4. Access the enable mode context:
ProCurve> enable
5. Access the global configuration mode:
ProCurve# configure terminal
Overview
Quick Start
1-27