Table of Contents
Advertisement
Handling static-sensitive devices
Attention:
To avoid damage, keep static-sensitive devices in their static-protective packages
until you are ready to install them.
To reduce the possibility of electrostatic discharge, observe the following
precautions:
v Limit your movement. Movement can cause static electricity to build up around
v The use of a grounding system is recommended. For example, wear an
v Handle the device carefully, holding it by its edges or its frame.
v Do not touch solder joints, pins, or exposed printed circuitry.
v Do not leave the device where others can handle and damage it.
v While the device is still in its static-protective package, touch it to an unpainted
v Remove the device from its package and install it directly into the switch without
v Take additional care when you handle devices during cold weather. Heating
Installing the RackSwitch in the standard equipment rack
This section describes how to install the RackSwitch in the standard 19-inch
equipment rack. For information about mounting the RackSwitch in other rack types,
see the following sections:
v "Installing the RackSwitch in the IBM iDataPlex rack" on page 20
v "Installing the RackSwitch in the IBM System x
The following parts come in the standard mounting kit.
Attention:
networking switch with only the front post mounting brackets (2-post application). If
the switch has an undesirable amount of sag, it is recommended to use a 4-post
mounting kit.
Attention:
Static electricity can damage the switch and other electronic devices.
you.
electrostatic-discharge wrist strap, if one is available.
metal part of any unpainted metal surface on a grounded rack component in the
rack in which you are installing the device, for at least 2 seconds. This drains
static electricity from the package and from your body.
setting it down. If it is necessary to set down the device, put it back into its
static-protective package. Do not place the device on a switch cover or on a
metal surface.
reduces indoor humidity and increases static electricity.
Table 12. 2-post rack mount kit parts
Item number
1
2
3
4
5
6
The rack-mounting frame may not be able to support the weight of the
For earthquake stability, mount the switch in a 4-post rack.
®
or Power rack" on page 22
Description
M6 locking washers
M6 screws
M6 clip nuts
M6 cage nuts
M4 screws
Mounting bracket
Chapter 2. Installing the RackSwitch and options
Quantity
4
4
4
4
8
2
17
Advertisement
Table of Contents
