Quick Entry Map; Quick Entry Map Table Of Contents - IBM pSeries 670 Service Manual

Quick Entry MAP

Quick Entry MAP Table of Contents

Problem Description
Service actions
The system attention LED on the media subsystem operator panel is on.
OK does not appear in the media subsystem operator panel display before pressing the
power-on button. Other symptoms appear in the media subsystem operator panel
display or LEDs before the power-on button is pressed.
8-Digit error codes
System stops with an 8-digit number displayed
System stops with a 4-digit number displayed that does not begin with 0 or 2.
System stops with a 3-digit number displayed (see below for 888 sequence).
Hardware Management Console (HMC) Problem
There appears to be a display problem (distortion, blurring, etc.)
Power and cooling problems
888 sequence in operator panel display
Other symptoms or problems
Attention: If you replace FRUs or perform an action on an I/O subsystem and the problem is still not
corrected, go to "MAP 1542: I/O Problem Isolation" on page 261 unless you were already directed to any
MAP 154x by the error code. Otherwise, call for support if the actions for an error code do not resolve the
problem.
If you replace FRUs or perform an action, and the problem is corrected, go to "MAP 410: Repair
Checkout" in the RS/6000 and Eserver pSeries Diagnostic Information for Multiple Bus Systems.
Note: If the only service actions that you perform are on the HMC, do not use MAP 410 to do the repair
checkout.
Chapter 3. Maintenance Analysis Procedures
Page No.
114
114
114
115
115
115
115
115
116
117
117
117
113