Table of Contents
Advertisement
Symptom
The system stops and a 3-digit number is
displayed in the operator panel display.
The system stops and a 4-digit number
beginning with 0 or 2 is displayed in the
operator panel display.
The system will not boot.
All other symptoms.
Quick Entry MAP
Quick Entry MAP Table of Contents
Problem Description
Service Actions
A Repeating Data Pattern Appears on the Operator Panel Display
OK Does Not Appear in the Primary I/O Drawer Operator Panel Display
Before Pressing the Power On Button
8-Digit Error Codes
System Stops With an 8-Digit Number Displayed
System Stops With a 4-Digit Number That Does Not Begin With 0 or 2
Displayed
System Stops With a 3-Digit Number Displayed
System Stops or Hangs With Alternating Numbers Displayed in the Operator
Display Panel.
There Is a Display Problem (Distortion, Blurring, Etc.)
Power and Cooling Problems
Flashing 888 in Operator Panel Display
Other Symptoms or Problems
You Cannot Find the Symptom in this Table
Attention:
corrected, go to "MAP 1540: Minimum Configuration" on page 57 unless otherwise
indicated in the tables.
If you replace FRUs or perform an action and the problem is corrected, go to "MAP
410: Repair Checkout" in RS/6000 and Eserver pSeries Diagnostic Information for
Multiple Bus Systems.
42
Service Guide
If you replace FRUs or perform an action and the problem is still not
Starting Point
Record SRN 101-xxx, where xxx is the 3-digit
number displayed in the operator panel display,
then go to the Fast Path MAP in the RS/6000
and Eserver pSeries Diagnostic Information
for Multiple Bus Systems.
Go to the Fast Path MAP in the RS/6000 and
Eserver pSeries Diagnostic Information for
Multiple Bus Systems.
Go to "Quick Entry MAP."
Go to "Quick Entry MAP."
Page No.
43
43
43
43
43
43
44
44
44
45
45
45
48
Advertisement
Table of Contents
