IBM pSeries 670 Service Manual page 159

Hide thumbs Also See for pSeries 670:

Table of Contents

Step 1322-34

While processing all service action events, were you directed to "Step 1322-14" on page 136?

If the system attention LED is still on, use the HMC to turn off the LED as described in "Resetting

the LED when a System is Attached To an HMC" on page 25. This completes the repair. Return

the system to the customer.

Note: If during the processing of the list of open service action events, some service action

events remained open, further service actions may be required to complete the repair.

Go to "Step 1322-35".

Step 1322-35

Perform the following steps for each entry in the list of "Axx" partitions you began recording in "Step

1322-14" on page 136, except the partition you were using to debug the original problem.

Step 1322-36

From the HMC virtual terminal window of a partition in the list of "Axx" partitions, type diag at the AIX

command prompt.

Step 1322-37

1. When the diagnostic operating instructions are displayed, press Enter.

2. Select the Task Selection option.

Note: If the terminal type is not defined, you are prompted to define it before you can proceed.

3. Select the Log Repair option.

4. Select the resource associated with the repair action. If the repair action was reseating a cable or

adapter, select the resource associated with that repair action. If the resource associated with your

repair action is not displayed on the Resource List, select sysplanar0.

5. Click commit after you have made your selection.

Step 1322-38

Exit from diagnostics in this partition and return to the AIX prompt.

Step 1322-39

Have all the partitions in the list of "Axx" partitions(s) you began recording in "Step 1322-14" on

page 136 been processed?

Go to "Step 1322-35" to process the next partition in the list you recorded in "Step 1322-14" on