IBM pSeries 670 Service Manual page 474

Error Code Description
4064 0EB9 Attention line 8 stuck fault
4064 0EBA Attention line 9 stuck fault
4064 0EBB Attention line 10 stuck fault
4064 0EBC Attention line 11 stuck fault
4064 0EBF Memory error
4064 0EE1 Processor subsystem tests detected fault in
service processor code (invalid MRU to
mapping)
4064 0EE2 Processor subsystem tests detected fault in
service processor firmware fault
4064 0EE5 Processor subsystem tests detected firmware
error; no callout available
4064 25E6 SMA 4-port switch adapter fault
4064 273F SMA 2-port switch adapter fault
4065 0001 Display alter tests detected clock card
assembly failure
4065 0002 Display alter tests detected backplane
assembly failure
4065 0003 Display alter tests detected fault in MCM
module 0
4065 0004 Display alter tests detected fault in MCM
module 2
4065 0005 Display alter tests detected fault in MCM
module 1
4065 0006 Display alter tests detected fault in MCM
module 3
454 Eserver pSeries 670 Service Guide
Action/
Possible Failing FRU
Go to "MAP 1540: Problem Isolation
Procedures" on page 253.
Go to "MAP 1540: Problem Isolation
Procedures" on page 253.
Go to "MAP 1540: Problem Isolation
Procedures" on page 253.
Go to "MAP 1540: Problem Isolation
Procedures" on page 253.
1. Reboot the system in slow mode to the
SMS menus. See "Performing Slow Boot"
on page 345.
2. Examine the service processor error log.
v If a CEC subsystem error (a 4xxx yyyy
error) occurred during the slow boot that
calls out the memory, processors, L3
cache modules, or the primary I/O book,
replace the part indicated by the location
code.
v If a CEC subsystem error (a 4xxx yyyy
error) did not occur during the slow boot,
look for a 4xxx yyyy error immediately
preceding the 406x 0EBF error. Replace
the part indicated by the location code
associated with that error.
1. Check for system firmware updates.
2. Call service support.
1. Check for system firmware updates.
2. Call service support.
1. Check for system firmware updates.
2. Call service support.
Replace the I/O book (switch adapter) specified
by the location code.
Replace the I/O book (switch adapter) specified
by the location code.
Go to "MAP 1540: Problem Isolation
Procedures" on page 253.
Go to "MAP 1540: Problem Isolation
Procedures" on page 253.
MCM module 0 and VPD card
Location: U1.18-P1-C1 and U1.18-P1-H2.3
MCM module 2 and VPD card
Location: U1.18-P1-C4 and U1.18-P1-H2.4
MCM module 1 and VPD card
Location: U1.18-P1-C3 and U1.18-P1-H2.5
MCM module 3 and VPD card
Location: U1.18-P1-C2 and U1.18-P1-H2.6