IBM pSeries 670 Service Manual page 586

Hide thumbs Also See for pSeries 670:
Table of Contents

Advertisement

Error Code Description
406C 0EB8 Attention line 7 stuck fault
406C 0EB9 Attention line 8 stuck fault
406C 0EBA Attention line 9 stuck fault
406C 0EBB Attention line 10 stuck fault
406C 0EBC Attention line 11 stuck fault
406C 0EBF Memory error
406C 0EE1 IPL detected fault in service processor code
(invalid MRU to mapping)
406C 0EE2 IPL detected fault in service processor firmware
fault
406C 0EE5 IPL detected firmware error; no callout available 1. Check for system firmware updates.
406C 25E6 SMA 4-port switch adapter fault
406C 273F SMA 2-port switch adapter fault
406D 0001 Attention handler detected clock card assembly
failure
406D 0002 Attention handler detected backplane assembly
failure
406D 0003 Attention handler detected fault in MCM module
0
406D 0004 Attention handler detected fault in MCM module
2
406D 0005 Attention handler detected fault in MCM module
1
406D 0006 Attention handler detected fault in MCM module
3
566
Eserver pSeries 670 Service Guide
Action/
Possible Failing FRU
Go to "MAP 1540: Problem Isolation
Procedures" on page 253.
Go to "MAP 1540: Problem Isolation
Procedures" on page 253.
Go to "MAP 1540: Problem Isolation
Procedures" on page 253.
Go to "MAP 1540: Problem Isolation
Procedures" on page 253.
Go to "MAP 1540: Problem Isolation
Procedures" on page 253.
1. Reboot the system in slow mode to the
SMS menus. See "Performing Slow Boot"
on page 345.
2. Examine the service processor error log.
v If a CEC subsystem error (a 4xxx yyyy
error) occurred during the slow boot that
calls out the memory, processors, L3
cache modules, or the primary I/O book,
replace the part indicated by the location
code.
v If a CEC subsystem error (a 4xxx yyyy
error) did not occur during the slow boot,
look for a 4xxx yyyy error immediately
preceding the 406x 0EBF error. Replace
the part indicated by the location code
associated with that error.
1. Check for system firmware updates.
2. Call service support.
1. Check for system firmware updates.
2. Call service support.
2. Call service support.
Replace the I/O book (switch adapter) specified
by the location code.
Replace the I/O book (switch adapter) specified
by the location code.
Go to "MAP 1540: Problem Isolation
Procedures" on page 253.
Go to "MAP 1540: Problem Isolation
Procedures" on page 253.
MCM module 0 and VPD card
Location: U1.18-P1-C1 and U1.18-P1-H2.3
MCM module 2 and VPD card
Location: U1.18-P1-C4 and U1.18-P1-H2.4
MCM module 1 and VPD card
Location: U1.18-P1-C3 and U1.18-P1-H2.5
MCM module 3 and VPD card
Location: U1.18-P1-C2 and U1.18-P1-H2.6

Advertisement

Table of Contents
loading

Table of Contents