Vpd Card - IBM pSeries 670 Service Manual

VPD Card

Notes:
1. The MCM module and its associated VPD card are a single FRU and must be replaced as a set.
2. There is only one VPD card for all of the L3 modules. Replacing any L3 module requires replacing the
associated VPD card.
The VPD cards are located in the primary I/O book.
Removal
1. Remove the primary I/O book (see "I/O Books and I/O Blanks" on page 792).
2. Use a T10 torx screw to remove the short cover near the connectors.
3. Locate the VPD card that must be replaced.
L3
CUoD
4. Remove the VPD card for the associated MCM or L3 modules.
Replacement
Replace in reverse order with the VPD card that was provided with the new MCM or L3 modules.
841
Chapter 9. Removal and Replacement Procedures