IBM pSeries 670 Service Manual page 235

Step 152i-11
Did the system stop with the same error code as recorded in "Step 152i-1" on page 214?
Yes The card just reinserted is defective. Replace it. This ends the procedure.
Return the system to its original configuration.
Go to "MAP 0410: Repair Checkout" in the RS/6000 and Eserver pSeries Diagnostic Information
for Multiple Bus Systems.
No Go to "Step 152i-12".
Step 152i-12
Have all the cards listed in "Step 152i-5" on page 214 been reinserted?
Yes The symptom has changed. This ends the procedure.
Return the system to its original configuration.
Go to "MAP 0410: Repair Checkout" in the RS/6000 and Eserver pSeries Diagnostic Information
for Multiple Bus Systems.
No Go to "Step 152i-9" on page 214.
Step 152i-13
Turn off the power.
Examine the green "power good out" LEDs of both I/O subsystem DCAs.
Step 152i-14
Are all the green "power good out" LEDs of both I/O subsystem DCAs off?
Yes Go to "Step 152i-15".
No Call for support.
Step 152i-15
Remove the following adapter cards, if present, from the I/O subsystem. Record the adapter locations:
v Adapter card at P1-I6
v Adapter card at P1-I7
v Adapter card at P1-I8
v Adapter card at P1-I9
v Adapter card at P1-I10
Step 152i-16
Turn on the power.
Step 152i-17
Did the system stop with the same error code as recorded in "Step 152i-1" on page 214?
Yes Go to "Step 152i-23" on page 216.
No Go to "Step 152i-18".
Step 152i-18
One of the cards just removed is defective.
Turn off the power.
Make sure all the green "power good out" LEDs of both I/O subsystem DCAs are off.
Step 152i-19
Reinsert one of the cards that is removed and listed in "Step 152i-15".
Chapter 3. Maintenance Analysis Procedures
215