Map 154B: Insufficient Hardware Resources Problem Isolation - IBM pSeries 670 Service Manual

Hide thumbs Also See for pSeries 670:

Table of Contents

MAP 154B: Insufficient Hardware Resources Problem Isolation

Record the error code, location code(s), and word 13 that sent you to this MAP.

Turn off the power.

Examine the amber logic-power LEDs of all installed processor subsystem DCAs.

Are all amber logic-power LEDs of all installed processor subsystem DCAs off?

Call for support.

Go to "Step 154B-4".

Before replacing any parts, examine the processor subsystem drawer to ensure that:

v At least one MCM (processor) module is installed.

v At least one memory card is installed.

v At least one L3 cache module is installed.

v The primary I/O book is installed.

Refer to the error code recorded in "Step 154B-1". When using the listings below, note the error code

condition before you replace parts that are called out. Replace the following FRUs, if present, one at a

Some of the parts in the following list are modules that have a limit of three plug cycles.

Before replacing any of the modules in the following list, call for support.

v First location code item recorded, if any, in "Step 154B-1".

v Second location code item recorded, if any, in "Step 154B-1".

v Third location code item recorded, if any, in "Step 154B-1".

Note: Replace the following FRUs only if they are associated with the word 13 that you recorded earlier.

If the value of word 13, recorded in "Step 154B-1", is 4110 0000 or 4060 0000, replace the following:

v Primary I/O book at U1.18-P1-H2 if not recorded in "Step 154B-1".

If the value of word 13, recorded in "Step 154B-1", is 403F 0000 or 40FF 0000, replace the following:

v Memory book 0 at U1.18-P1-M2 if not recorded in "Step 154B-1".

v Memory book 1 at U1.18-P1-M3 if not recorded in "Step 154B-1"

v Memory book 2 at U1.18-P1-M7 if not recorded in "Step 154B-1"

v Memory book 3 at U1.18-P1-M6 if not recorded in "Step 154B-1".

If the value of word 13, recorded in "Step 154B-1", is 402F 0000, replace the following:

v MCM module 0 at U1.18-P1-C1 if not recorded in "Step 154B-1".

v MCM module 2 at U1.18-P1-C4 if not recorded in"Step 154B-1".

v MCM module 1 at U1.18-P1-C3 if not recorded in "Step 154B-1".

v MCM module 3 at U1.18-P1-C2 if not recorded in "Step 154B-1".

Chapter 3. Maintenance Analysis Procedures

Table of Contents