Media Subsystem Chassis - IBM pSeries 670 Service Manual

Media Subsystem Chassis

Removal
1. Turn off power as described in "Powering Off and Powering On the System" on page 779.
2. Label and disconnect all cables from the rear of the media subsystem.
3
2 5
1
SCSI
SCSI
8
6 7
4
3. Remove the screw that holds the left side of the media subsystem chassis to the rack.
4. Remove the screw that holds the right side of the media subsystem chassis to the rack.
1 2 3 4
SCSI
SCSI
5. Carefully pull the chassis out of the front of the rack.
Replacement
Replace in reverse order.
If the new media drawer contains a new operator panel, remove the VPD module from the old operator
panel and insert it in the new operator panel. Make sure you insert the module in the same position as it
was in the old panel. Be sure to move any other parts or features from the old media drawer to the new
media drawer if they are not included as part of the new media drawer.
939
Chapter 9. Removal and Replacement Procedures